How to Remove Fused Edge During Fabric Cutting

How to Remove Fused Edge During Fabric Cutting?

Fused edge in cutting fabric is one of the major faults of cutting section in the readymade garments sector. It hampers the whole process of apparel manufacturing. So, it is too much needy to remove these kinds of faults from the cutting section for achieving better output from a garment export order. There are some ways to remove the fused edge from fabric cutting which has explained in this article clearly.

Cutting Section in Garments Industry

Cutting Section in Garments Industry

Fused Edge in Fabric:

During fabric cutting, when the parts of the fabric are cut from the fabric layer, there is generated friction between the fabric and the cutting knife. As a result, heat is generated in the cutting knife. Sometimes it’s seen that excessive heat generation by friction may cause a burn of the edge of cutting fabric. It affects deeply in the case of thermoplastic fiber.

Removal Ways of Fused Edge Produced in Fabric Cutting:

There are some key points, which helps to remove the fused edge during fabric cutting are mentioned in the following:

  1. Reducing ply height,
  2. Sharpening the knife properly,
  3. Using silicon lubricating agents during cutting,
  4. Using anti fusing paper,
  5. Reducing the speed of cutting knife.

All the above key points have explained the below:

1. Reducing ply height:

During fabric spreading, one thing should be carefully handled the number of plies not more than three hundred. If it exceeds the definite number then there is too much possibility of producing fused edge in the fabric. So, by reducing ply height, we should easily remove the possibility of producing fused edges in the cutting fabric.

2. Sharpening the knife properly:

It is one of the important points during cutting the fabric. The cutting knife must be sharpening properly, otherwise, it will create problems during fabric cutting and produced fused edges in the fabric.

3. Using silicon lubricating agents during cutting:

Using a silicon lubricating agent in the cutting knife helps to remove the fused edge in the cutting fabric.

4. Using anti fusing paper:

It is the other way that reduces the possibility of producing a fused edge in the fabric. So, during fabric cutting, anti fusing paper should be used for getting fault free cutting fabrics.

5. Reducing the speed of the cutting knife:

Sometimes it is seen that fabrics are cut by using a cutting knife at fast speed. But it creates the possibility of producing fused edges in the cutting fabrics. So, cutting knife speed must be reduced to get fault free cutting fabrics.

2 comments

Leave a Reply to Rakibul Islam Cancel reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.